Author Topic: Ford High Pinion Dana 44 Axle  (Read 1920 times)

Meatywand

  • Hero Member
  • *****
  • Posts: 15769
  • Karma: 688
  • Broo Penis
    • NecroManor
Ford High Pinion Dana 44 Axle
« on: September 24, 2013, 12:17:19 PM »
With my TJ dead and gone, I have no use for this axle anymore, and I guess the guy that bought my Jeep doesn't want it either since I haven't heard from him about picking it up. It's a 197(?) Ford High Pinion Dana 44. It's in decent shape, needs brakes and probably the locking hubs need to be rebuilt along with any gears/locker you want to install. Its only a couple inches wider than a stock TJ axle so you can run it on the street without cutting it down. I haven't done anything to it other than simply store it in my garage, and I'd like to clear it out of there.

$300 OBO

Quote from:  Sergeant D
Nothing says Alpha like getting your anus violated by another man

I gazed through the open window upon a full moon.
His name was Meatywand.

jeepidude

  • Hero Member
  • *****
  • Posts: 1645
  • Karma: 8
  • Ford/Dodge/Hondadude
    • Facebook
Re: Ford High Pinion Dana 44 Axle
« Reply #1 on: September 24, 2013, 01:31:50 PM »
If it was a passenger side diff I would be all over it  :(

AirForceOne

  • Hero Member
  • *****
  • Posts: 883
  • Karma: 7
Re: Ford High Pinion Dana 44 Axle
« Reply #2 on: September 29, 2013, 11:00:16 PM »
What's the width on the spring pads, and width hub to hub?

Meatywand

  • Hero Member
  • *****
  • Posts: 15769
  • Karma: 688
  • Broo Penis
    • NecroManor
Re: Ford High Pinion Dana 44 Axle
« Reply #3 on: September 29, 2013, 11:05:40 PM »
I'll have to get back with you...I'm still in the hospital...but its like an inch or inch and a quarter wider than a stock TJ just to give you an idea until I can measure it.
Quote from:  Sergeant D
Nothing says Alpha like getting your anus violated by another man

I gazed through the open window upon a full moon.
His name was Meatywand.